Meter / Gauge System: Precaution

REMOVAL AND INSTALLATION OF THE BATTERY TERMINAL

Before performing electrical work, disconnect the battery negative (-) terminal in order to prevent a short in the system.

Fig 1: Disconnecting Battery Negative (-) Terminal
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
When disconnecting and reconnecting the battery cable, turn the ignition switch and lighting switches off and loosen the terminal nut completely. Perform these operations without prying on the terminal.

When the battery terminal is removed, the memories of the clock, radio, DTCs, etc. are erased. So before removing the terminal, check and make a note of them.

NOTE: When disconnecting the battery negative (-) terminal, initialize the following system after the terminal is reconnected.

SYSTEM NAME REFERENCE

System Name	See Procedure
Lighting System	INITIALIZATION
Power Window Control System
Power Door Lock Control System
Power Back Door System
Back Door Closer System
Electrical Back Door Outside Handle System
SFI System