Spiral Cable: Installation

INSTALL STEERING ANGLE SENSOR (See INSTALLATION )
INSTALL SPIRAL CABLE
1. Check that the front wheels are facing straight ahead.
2. Set the turn signal switch to the neutral position.
  NOTE: If it is not in the neutral position, the pin of the turn signal switch may snap.
3. Install the spiral cable.
  NOTE: When replacing the spiral cable with a new one, remove the lock pin before installing the steering wheel assembly.
4. Connect the connectors to the spiral cable.
  
  Fig 1: Identifying Spiral Cable Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  NOTE: When handling the airbag connector, take care not to damage the airbag wire harness.
INSTALL STEERING COLUMN COVER (for Manual Tilt) (See INSTALLATION )
INSTALL STEERING COLUMN COVER (for Power Tilt and Power Telescopic) (See INSTALLATION )
ADJUST SPIRAL CABLE
1. Check that the ignition switch is off.
2. Check that the battery negative (-) terminal is disconnected.
  CAUTION: After removing the terminal, wait for at least 90 seconds before starting the operation.
3. Rotate the spiral cable counterclockwise slowly by hand until it feels firm.
  NOTE: Do not turn the spiral cable by the airbag wire harness.
  
  Fig 2: Rotating Spiral Cable Counterclockwise
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Rotate the spiral cable clockwise approximately 2.5 turns to align the marks.
  NOTE: Do not turn the spiral cable by the airbag wire harness.
  
  HINT:
  
  The spiral cable will rotate approximately 2.5 turns to both the left and right from the center.
  
  Fig 3: Rotating Spiral Cable Clockwise Approximately 2.5 Turns To Align Marks
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL STEERING WHEEL ASSEMBLY (for Manual Tilt) (See INSTALLATION )
INSTALL STEERING WHEEL ASSEMBLY (for Power Tilt and Power Telescopic) (See INSTALLATION )
INSPECT STEERING WHEEL CENTER POINT
INSTALL STEERING PAD (See INSTALLATION )
INSTALL STEERING WHEEL NO.2 COVER LOWER (See INSTALLATION )
INSTALL STEERING WHEEL NO.3 COVER LOWER (See INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
INSPECT STEERING PAD (See INSTALLATION )
INSPECT SRS WARNING LIGHT
1. Inspect the SRS warning light (See DIAGNOSIS SYSTEM ).