LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2008 >> RX 350 AWD >> Repair and Diagnosis >> Restraints >> Seat Belts >> Seat Belt >> Front Seat Outer Belt Assembly With PRETENSIONER >> Removal

Front Seat Outer Belt Assembly With PRETENSIONER: Removal

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait for 90 seconds after disconnecting the cable to prevent the airbag working (See PRECAUTION ).
  2. REMOVE FRONT DOOR SCUFF PLATE  (See REMOVAL )
  3. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP 
  4. REMOVE REAR DOOR SCUFF PLATE  (See REMOVAL )
  5. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP 
  6. REMOVE LAP BELT OUTER ANCHOR COVER 
    1. Disengage the 2 claws and remove the lap belt outer anchor cover.
      Fig 1: Identifying Lap Belt Outer Anchor Cover Claws
      G05242872Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  7. DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY 
    1. Remove the bolt and disconnect the floor side of the front seat outer belt assembly.
  8. REMOVE CENTER PILLAR GARNISH LOWER  (See REMOVAL )
  9. REMOVE CENTER PILLAR GARNISH  (See REMOVAL )
  10. REMOVE FRONT SEAT OUTER BELT ASSEMBLY 
    1. Turn the ignition switch to the Lock position.
    2. Remove the nut and disengage the shoulder side of the front seat outer belt assembly.
    3. Using a screwdriver, pull out the locking button in the direction shown by the arrow to release the lock, and disconnect the pretensioner connector.

      HINT:

      Tape the screwdriver tip before use.

    4. Disconnect the tension reducer connector.
      Fig 2: Identifying Tension Reducer Connector
      G05242874Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    5. Remove the 2 bolts and front seat outer belt assembly.
      Fig 3: Identifying Front Seat Outer Belt Assembly Bolts
      G05242875Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals