Installation

WIPER / WASHER: REAR WIPER MOTOR: INSTALLATION


1. INSTALL REAR WIPER MOTOR ASSEMBLY






(a) Temporarily install the rear wiper motor assembly with the 3 bolts.
(b) Tighten the 3 bolts.
Torque: 5.5 Nm (56 kgf-cm, 49 in-lbf)
(c) Connect the connector.
2. INSTALL REAR WIPER MOTOR GROMMET Reassembly

3. INSTALL REAR WIPER ARM Reassembly

4. INSTALL BACK DOOR GARNISH Reassembly

5. INSTALL BACK DOOR SIDE GARNISH LH Reassembly

6. INSTALL BACK DOOR SIDE GARNISH RH Reassembly

7. INSTALL CENTER BACK DOOR GARNISH Reassembly