Replacement

AXLE AND DIFFERENTIAL: FRONT AXLE HUB BOLT: REPLACEMENT

HINT:
- Use the same procedures for the LH side and RH side.
- The procedures listed below are for the LH side.

1. REMOVE FRONT WHEEL
2. DISCONNECT FRONT DISC BRAKE CALIPER ASSEMBLY LH Removal

3. REMOVE FRONT DISC Removal

4. REMOVE FRONT AXLE HUB BOLT LH






(a) Using SST and a screwdriver or equivalent to hold the axle hub, remove the front axle hub bolt.
SST: 09650-17011
NOTICE:
Do not damage the threads of the hub bolt.

5. INSTALL FRONT AXLE HUB BOLT LH






(a) Temporarily install a washer and hub nut to a new hub bolt as shown in the illustration.
NOTICE:
Install a hub nut to prevent damage to the hub bolt.

(b) Using a screwdriver or equivalent to hold the hub, turn the hub nut until the bottom surface of the hub bolt head touches the axle hub.
(c) Remove the washer and hub nut.
NOTICE:
Do not damage the threads of the hub bolt.

6. INSPECT FRONT AXLE HUB BEARING LOOSENESS Testing and Inspection

7. INSPECT FRONT AXLE HUB RUNOUT Testing and Inspection

8. INSTALL FRONT DISC Installation

9. CONNECT FRONT DISC BRAKE CALIPER ASSEMBLY LH Installation

10. INSTALL FRONT WHEEL
Torque: 131 Nm (1336 kgf-cm, 97 ft-lbf)