Installation

SUSPENSION CONTROL: SUSPENSION CONTROL CYLINDER: INSTALLATION





1. INSTALL CENTER SUSPENSION CONTROL CYLINDER SUB-ASSEMBLY
(a) Install the cylinder to the bracket with the 2 nuts.
Torque: 31 Nm (316 kgf-cm, 23 ft-lbf)






2. INSTALL HEIGHT CONTROL BRACKET WITH CYLINDER ASSEMBLY
(a) Install the bracket with cylinder with the 2 bolts.
Torque: 31 Nm (316 kgf-cm, 23 ft-lbf)






3. CONNECT NO. 3 HEIGHT CONTROL TUBE LH
(a) Install a new gasket to the No. 3 height control tube, and then connect the height control tube to the control cylinder with the union bolt.
Torque: 50 Nm (510 kgf-cm, 37 ft-lbf)






4. CONNECT NO. 4 HEIGHT CONTROL TUBE
(a) Install a new gasket to the No. 4 height control tube, and then connect the height control tube to the control cylinder with the union bolt.
Torque: 50 Nm (510 kgf-cm, 37 ft-lbf)






5. CONNECT NO. 4 HEIGHT CONTROL TUBE LH
(a) Install a new gasket to the No. 4 height control tube, and then connect the height control tube to the control cylinder with the union bolt.
Torque: 50 Nm (510 kgf-cm, 37 ft-lbf)






6. CONNECT NO. 3 HEIGHT CONTROL TUBE
(a) Install a new gasket to the No. 3 height control tube, and then connect the height control tube to the control cylinder with the union bolt.
Torque: 50 Nm (510 kgf-cm, 37 ft-lbf)
7. INSTALL NO. 1 HEIGHT CONTROL VALVE ASSEMBLY Installation

8. CONNECT REAR NO. 4 HEIGHT CONTROL TUBE Installation

9. INSTALL NO. 5 HEIGHT CONTROL TUBE Installation

10. INSTALL NO. 5 HEIGHT CONTROL TUBE LH Installation

11. INSTALL NO. 6 HEIGHT CONTROL TUBE LH Installation

12. INSTALL NO. 6 HEIGHT CONTROL TUBE Installation

13. INSTALL CLAMP Installation

14. INSTALL SUSPENSION CONTROL PUMP ACCUMULATOR ASSEMBLY Installation

15. INSTALL NO. 7 HEIGHT CONTROL TUBE Installation

16. BLEED AIR FROM SUSPENSION FLUID Service and Repair

17. CHECK FLUID LEVEL IN RESERVOIR Suspension Control System

18. INSPECT FOR SUSPENSION FLUID LEAK Suspension Control System

19. INSTALL HEIGHT CONTROL UNIT INSULATOR Installation

20. INSTALL CENTER EXHAUST PIPE ASSEMBLY Installation

21. INSTALL TAILPIPE ASSEMBLY Installation

22. INSPECT FOR EXHAUST GAS LEAK
- If gas is leaking, tighten the areas necessary to stop the leak. Replace damaged parts as necessary.