Installation

SUSPENSION CONTROL: FRONT ACCELERATION SENSOR: INSTALLATION

1. INSTALL ACCELERATION SENSOR (for Driver Side)






(a) Install the sensor with the bolt.
Torque: 8.0 Nm (82 kgf-cm, 71 in-lbf)
(b) Connect the connector.
2. INSTALL ACCELERATION SENSOR (for Front Passenger Side)






(a) Install the sensor with the bolt.
Torque: 8.0 Nm (82 kgf-cm, 71 in-lbf)
(b) Connect the connector.
3. INSTALL STEERING CONTROL ECU WITH JUNCTION BLOCK






(a) Front Side:
(1) Connect the 5 connectors.
(b) Rear Side:
(1) Install the steering control ECU with junction block to the vehicle with the bolt and 2 nuts.
Torque: 8.0 Nm (82 kgf-cm, 71 in-lbf)
(2) Attach the 2 clamps.
(3) Connect the 7 connectors.
4. INSTALL LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL Installation

5. INSTALL INSTRUMENT PANEL BOX DOOR KNOB Installation

6. INSTALL FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY Installation

7. INSTALL COWL SIDE TRIM BOARD RH Installation

8. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Installation

9. INSTALL FRONT DOOR SCUFF PLATE RH Installation

10. INSTALL NO. 3 INSTRUMENT CLUSTER FINISH PANEL GARNISH Installation

11. INSTALL NO. 4 INSTRUMENT PANEL REGISTER ASSEMBLY Installation

12. INSTALL INSTRUMENT SIDE PANEL RH Installation

13. INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY Installation

14. INSTALL INSTRUMENT PANEL BOX ASSEMBLY Installation

15. INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL Installation

16. INSTALL COWL SIDE TRIM BOARD LH Installation

17. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Installation

18. INSTALL FRONT DOOR SCUFF PLATE LH Installation

19. INSTALL NO. 1 SWITCH HOLE BASE Installation

20. INSTALL INSTRUMENT SIDE PANEL LH Installation

21. INSTALL LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY Installation

22. INSTALL INNER NO. 1 INSTRUMENT PANEL BRACKET COVER RH Installation

23. INSTALL LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY RH Installation

24. INSTALL INNER NO. 1 INSTRUMENT PANEL BRACKET COVER LH Installation

25. INSTALL LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH Installation

26. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

27. CHECK SRS WARNING LIGHT
(a) Check the SRS warning light Diagnosis System.