Installation

3UR-FE ENGINE CONTROL: CAMSHAFT POSITION SENSOR: INSTALLATION

3UR-FE ENGINE CONTROL: CAMSHAFT POSITION SENSOR: INSTALLATION

1. INSTALL VVT SENSOR






(a) Install the 4 sensors with the 4 bolts.
Torque: 10 Nm (102 kgf-cm, 7 ft-lbf)
(b) Connect the 4 sensor connectors.






2. INSTALL CAMSHAFT POSITION SENSOR
(a) Install the sensor with the bolt.
Torque: 10 Nm (102 kgf-cm, 7 ft-lbf)
(b) Connect the sensor connector.
3. INSTALL AIR CLEANER HOSE ASSEMBLY Installation

4. INSTALL V-BANK COVER SUB-ASSEMBLY Installation

5. INSTALL UPPER RADIATOR SUPPORT SEAL Installation

6. INSTALL ENGINE ROOM SIDE COVER RH Installation

7. INSTALL ENGINE ROOM SIDE COVER LH Installation