Installation

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: SKID CONTROL BUZZER: INSTALLATION


1. INSTALL SKID CONTROL BUZZER ASSEMBLY






(a) Connect the buzzer connector.
NOTICE:
Securely connect the connector.

(b) Attach the clamp to install the buzzer.
NOTICE:
- Securely insert the clamp into the bracket.
- If the buzzer is dropped, replace it.

2. INSTALL NO. 1 SWITCH HOLE BASE Installation

3. INSTALL INSTRUMENT SIDE PANEL Installation

4. INSTALL INSTRUMENT PANEL BOX ASSEMBLY Installation

5. INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL Installation

6. INSTALL COWL SIDE TRIM BOARD LH Installation

7. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Installation

8. INSTALL FRONT DOOR SCUFF PLATE LH Installation

9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.