Installation

1. Install seat into vehicle.

A. Temporarily install seat with the 4 bolts.

NOTICE

Be careful not to damage vehicle body or interior components.

B. Tighten the bolts in the sequence shown.
Torque: 37 N*m (377 kgf*cm, 27 ft*lbf)

C. Connect the connector.

D. Connect the battery terminal.

NOTE

Some Systems must be initialized after the battery is disconnected, please refer to the following Technical Information System (TIS), applicable model and model year Repair Manual:

^ 2008 / 2009 LX 570:
General - Introduction - "Repair Instruction: Initialization"





E. Install seat hinge cover.





F. Install the seat hinge cushion cover.

2. Cycle rear seat to confirm proper operation is restored.