Canada -Towing - Installation Towing Wire Harness
BulletinTSB2548
Issue Date
December 19, 2007
Title
INSTALLATION OF TOWING WIRE HARNESS CONNECTOR DURING PDS
Component
GENERAL INFORMATION
Models
'08 - '09 LX 570
INTRODUCTION:
The towing wire harness connector set (contains towing wire harness connector assembly and 2 bolts) is loaded in the vehicle at the assembly plant. Use the following procedure to Install the towing wire harness connector to the vehicle during Pre-Delivery Service (PDS).
APPLICABLE VEHICLES:
- 2008-2009 model year LX 570 vehicles.
WARRANTY INFORMATION:
INSTALLATION PROCEDURES:
1. Connect the frame wire harness and the towing wire harness connector.
A. Remove the water resistant caps from the 2 frame wire harness connectors.
B. Connect the 2 frame wire harness connectors and 2 towing wire harness connectors.
2. Install the towing wire harness assembly bracket to the frame bracket with the 2 bolts.
Torque: 19.5 N-m (199 kgf-cm, 14 ft-lbf)