Wheel Opening Moulding: Removal

HINT.

• Use the same procedures for the RH side and LH side
• The procedures listed below are for the LH side.

1. REMOVE FRONT FENDER WHEEL OPENING MOULDING LH 
   1. Remove the 5 screws
   2. Detach the clip and remove the moulding
   Fig 1: Identifying Front Fender Wheel Opening Moulding LH

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. REMOVE QUARTER PANEL WHEEL OPENING MOULDING LH 
   1. Remove the 4 screws and moulding
   Fig 2: Identifying Front Fender Wheel Opening Moulding And Screws
   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002