Typical Enabling Conditions
Misfire:
TYPICAL ENABLING CONDITIONS
| Monitor runs whenever following DTCs are not present | P0102, P0103, P010C, P010D (MAF meter) P0097, P0098, P0112, P0113 (IAT sensor) P0115 - P0118 (ECT sensor) P0120 - P0223, P2135 (TP sensor) P0125 (Insufficient ECT for Closed Loop) P0327 - P033D (Knock sensor) P0335 (CKP sensor) P0340 (VVT sensor) P0500 (VSS) |
| Battery voltage | 8 V or more |
| VVT system | Not operated by scan tool |
| Engine RPM | 325 to 6600 rpm |
| Either of the following conditions 1 and 2 are met: | - |
| 1. ECT at engine start | More than -7°C (19°F) |
| 2. ECT | More than 20°C (68°F) |
| Fuel cut | OFF |
Monitor period of emission-related-misfire:
TYPICAL ENABLING CONDITIONS
| First 1000 revolutions after engine start, or Check Mode | Crankshaft 1000 revolutions |
| Except above | Crankshaft 1000 revolutions x 4 |
Monitor period of catalyst-damaged-misfire (MIL blinks):
TYPICAL ENABLING CONDITIONS
| All of following conditions 1, 2 and 3 are met: | Crankshaft 200 revolutions x 3 |
| 1. Driving cycles | 1st |
| 2. Check mode | OFF |
| 3. Engine RPM | Less than 2200 rpm |
| Except above (MIL blinks immediately) | Crankshaft 200 revolutions |