LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2008 >> IS 250 RWD, Automatic >> Repair and Diagnosis >> Transmission >> Automatic Trans >> A960E Automatic Transaxle >> Valve Body Assembly >> Removal

Valve Body Assembly: Removal

  1. DRAIN AUTOMATIC TRANSMISSION FLUID  (See REMOVAL )
  2. REMOVE NO. 1 EXHAUST PIPE SUPPORT BRACKET SUB-ASSEMBLY  (See REMOVAL )
  3. REMOVE AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY  (See REMOVAL )
  4. REMOVE VALVE BODY OIL STRAINER ASSEMBLY  (See REMOVAL )
  5. DISCONNECT TRANSMISSION WIRE  (See REMOVAL )
  6. REMOVE TRANSMISSION VALVE BODY ASSEMBLY 
    1. Remove the 19 bolts and valve body.
      Fig 1: Locating Valve Body Bolts
      G05318199Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Separate the lever pin from the manual valve.
      Fig 2: Identifying Lever Pin From Manual Valve
      G05318200Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Remove the check ball body and spring.
      NOTE: Do not drop the check ball body and spring.
      Fig 3: Identifying Check Ball Body And Spring
      G05294783Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals