LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2008 >> IS 250 RWD, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (M/T Clutch) >> Clutch Release Cylinder >> Reassembly

Clutch Release Cylinder: Reassembly

WARNING: This page is about a different variant/trim than selected.
  1. INSTALL RELEASE CYLINDER BLEEDER PLUG 
    1. Install the release cylinder bleeder plug to the cylinder body.

      Torque: 11 N*m (112 kgf*cm, 8 ft.*lbf) 

    2. Install the bleeder plug cap to the bleeder plug.
  2. INSTALL RELEASE CYLINDER PISTON 
    1. Install the spring to the cylinder body.
    2. Apply lithium soap base glycol grease to the portions shown in the illustration.
    3. Install the piston to the cylinder body.
      NOTE: Be careful not to damage the inside of the cylinder body.
      Fig 1: Locating Lithium Soap Base Glycol Grease Application Areas
      G04831604Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Install the push rod to the boot.
    5. Install the boot (with push rod) to the cylinder body.
scientia non olet · About LEMON Manuals