LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2008 >> IS 250 RWD, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (M/T Clutch) >> Clutch Release Cylinder >> Disassembly

Clutch Release Cylinder: Disassembly

WARNING: This page is about a different variant/trim than selected.
  1. REMOVE RELEASE CYLINDER PISTON 
    1. Remove the boot from the cylinder body.
    2. Remove the push rod from the cylinder body.
      Fig 1: Locating Clutch Release Cylinder
      G05830170Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Using compressed air, remove the piston together with the spring from the cylinder.
      NOTE: Be careful not to damage the inside of the cylinder body.
      Fig 2: Removing Piston Using Compressed Air
      G05111100Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. REMOVE RELEASE CYLINDER BLEEDER PLUG 
    1. Remove the bleeder plug cap from the bleeder plug.
    2. Remove the release cylinder bleeder plug from the cylinder body.
scientia non olet · About LEMON Manuals