LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2008 >> IS 250 RWD, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (RA62 Manual Transmission) >> Output Shaft >> Reassembly

Output Shaft: Reassembly

WARNING: This page is about a different variant/trim than selected.
  1. INSTALL OUTPUT SHAFT FRONT BEARING 
    1. Using SST and a press, install a new output shaft front bearing onto the output shaft.

      SST 09710-20011 (09710-06061), 09950-60010 (09951-00650) 

    2. Apply a light coat of grease to the bearing.
  2. INSTALL OUTPUT SHAFT CENTER BEARING 
    1. Apply gear grease to the output shaft center bearing, and install it onto the output shaft.
      Fig 1: Installing No. 3 Synchronizer Ring
      G05824837Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. INSTALL NO. 3 SYNCHRONIZER RING 
    1. Apply gear oil to the No. 3 synchronizer ring, and install it onto the output shaft.
scientia non olet · About LEMON Manuals