System Description
WARNING: This page is about a different variant/trim than selected.
The 1-2 shift valve performs shifting to 1st gear and other gears.
DTC DETECTION CONDITION CHART
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| P0781 | 1-2 shift valve malfunction: Shifting to 2nd and 4th gears is impossible. When the ECM directs the gearshift to switch to 5th or 6the gear, the engine overruns (clutch slips). (2-trip detection logic) (a) and (b), or (a) and (c)
|
|
HINT:
- Gear positions in the event of a solenoid valve mechanical problem:GEAR POSITION CHART
ECM command gearshift 1st 2nd 3rd 4th 5th 6th Actual gear position under malfunction ↑ 1st ↑ 3rd (1) (1) (1) Neutral - Gear position during fail-safe operation:
If any malfunction is detected, the ECM changes into the fail-safe mode to shift into the gear positions as shown in the table below.
GEAR POSITION CHARTGear position under normal conditions 1st 2nd 3rd 4th 5th 6th Actual gear position under fail safe mode ↑((1)) 1st ((1)) ↑ 3rd 3rd 3rd (1) Under engine braking, downshifting to 1st or 2nd gear is prohibited.