Multiplex Tilt And Telescopic Ecu: Installation

WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL MULTIPLEX TILT AND TELESCOPIC ECU
1. Install the multiplex tilt and telescopic ECU with the 2 screws
  Torque: 1.5 N*m (15 kgf*cm, 13 in.*lbf)
  
  Fig 1: Identifying Multiplex Tilt And Telescopic ECU Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Connect the connector to the multiplex tilt and telescopic ECU.
  NOTE:
  - The connectors on both ends of the wire harness between the telescopic motor and ECU are the same shape.
  - When installing them, connect the connectors of the same color.
INSTALL STEERING LOCK ACTUATOR ASSEMBLY (See REASSEMBLY )

Fig 2: Locating Multiplex Tilt And Telescopic ECU Connector
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL STEERING COLUMN ASSEMBLY
HINT:

Refer to the instructions for Installation of the steering column assembly (See REASSEMBLY )