LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2008 >> IS 250 RWD, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 7 ((Door / Hatch)) >> Luggage Compartment Door Opener System >> Data List / Active Test

Data List / Active Test

WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.
  1. READ DATA LIST 

    HINT:

    Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed Reading the Data List information early in troubleshooting is one way to save diagnostic time.

    NOTE: In the following table, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
    1. Connect the Techstream to the DLC3.
    2. Turn the engine switch on (IG)
    3. Turn the Techstream on.
    4. Enter the following menus Body Electrical / Body / Data List.
    5. Read the Data List according to the display on the Techstream.

      Body 

      ITEM RANGE REFERENCE

      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Trunk/B Door Open SW Luggage door opener inner switch signal/ON or OFF ON Luggage compartment door opener inner switch is pushed
      OFF Luggage compartment door opener inner switch is not pushed      		 -
      Trunk Main SW Luggage door opener main switch signal/ON or OFF ON Luggage compartment door opener main switch is pushed
      OFF Luggage compartment door opener main switch is not pushed      		 -
  2. PERFORM ACTIVE TEST 

    HINT:

    Using the Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

    1. Connect the Techstream to the DLC3.
    2. Turn the engine switch on (IG)
    3. Turn the Techstream on.
    4. Enter the following menus. Body Electrical / Body / Active Test
    5. Perform the Active Test according to the display on the Techstream.

      Body 

      ITEM RANGE REFERENCE

      Tester Display Test Part Control Range Diagnostic Note
      Trunk and Back-Door Open Operate luggage compartment door lock motor ON/OFF -
scientia non olet · About LEMON Manuals