LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2008 >> IS 250 RWD, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 7 ((Door / Hatch)) >> Fuel Lid Opener Motor Assembly >> Installation

Fuel Lid Opener Motor Assembly: Installation

WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL FUEL LID OPENER MOTOR ASSEMBLY 
    1. Install the fuel lid opener motor assembly with the nut.

      Torque: 5.5 N*m (56 kgf*cm, 49 in.*lbf) 

    2. Install the lock as shown in the illustration
    3. Connect the connector
    Fig 1: Installing Fuel Lid Opener Motor Assembly
    G05321365Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL SIDE LUGGAGE COMPARTMENT TRIM COVER  (See INSTALLATION )
  3. INSTALL NO. 1 LUGGAGE COMPARTMENT TRIM HOOK  (See INSTALLATION )
  4. INSTALL FRONT LUGGAGE COMPARTMENT TRIM COVER  (See INSTALLATION )
  5. INSTALL NO. 2 LUGGAGE COMPARTMENT TRIM HOOK  (See INSTALLATION )
  6. INSTALL ROPE HOOK  (See INSTALLATION )
  7. INSTALL NO. 2 ROOM LIGHT ASSEMBLY  (See INSTALLATION )
  8. INSTALL REAR LUGGAGE COMPARTMENT TRIM COVER  (See INSTALLATION )
  9. INSTALL ROPE HOOK ASSEMBLY  (See INSTALLATION )
  10. INSTALL DECK SIDE TRIM BOX RH 
  11. INSTALL DECK SIDE TRIM BOX LH 
  12. INSTALL NO. 2 LUGGAGE COMPARTMENT TRIM COVER 
scientia non olet · About LEMON Manuals