Injector Driver: Removal

WARNING: This page is about a different car, the 2008 Lexus IS 350. However, it is still accessible from the selected car via links, so may be relevant.

REMOVE COOL AIR INTAKE DUCT SEAL (See REMOVAL )
REMOVE NO. 1 INLET AIR CLEANER (See REMOVAL )
REMOVE NO. 1 ENGINE COVER (See REMOVAL )
REMOVE INJECTOR DRIVER
1. Move the lock lever in the direction indicated by the arrow to release the connector lock. Disconnect the 3 connectors with wire harness locks and the connector from the injector driver.
  
  Fig 1: Locating Connectors With Wire Harness Locks
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Remove the bolt, 2 nuts and injector driver.
NOTE: Be careful not to drop or strike the injector driver.

Fig 2: Locating Injector Driver Bolt And Nuts
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002