LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2008 >> IS 250 RWD, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 59 (Fuel (2GR-FSE)) >> Fuel Sender Gauge Assembly >> Installation

Fuel Sender Gauge Assembly: Installation

WARNING: This page is about a different car, the 2008 Lexus IS 350. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL FUEL SENDER GAUGE ASSEMBLY (for RH Side)  (See INSTALLATION )
  2. INSTALL FUEL SENDER GAUGE ASSEMBLY (for LH Side)  (See INSTALLATION )
  3. INSTALL FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY  (See INSTALLATION )
  4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
  5. INSPECT FOR FUEL LEAK  (See ON-VEHICLE INSPECTION )
  6. INSTALL REAR FLOOR SERVICE HOLE COVER  (See INSTALLATION )
  7. INSTALL NO. 2 REAR FLOOR SERVICE HOLE COVER  (See INSTALLATION )
  8. INSTALL REAR SEAT CUSHION ASSEMBLY  (See INSTALLATION )
  9. PERFORM INITIALIZATION 
NOTE: Some systems need initialization after reconnecting the cable to the negative battery terminal (See INITIALIZATION ).
scientia non olet · About LEMON Manuals