LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2008 >> IS 250 RWD, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 59 (Fuel (2GR-FSE)) >> Fuel Pump Resistor >> Installation

Fuel Pump Resistor: Installation

WARNING: This page is about a different car, the 2008 Lexus IS 350. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL FUEL PUMP RESISTOR 
    1. Install the fuel pump resistor with the bolt.

      Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf) 

    2. Install the ground wires with the 2 bolts.

      Torque: 8.0 N*m (80 kgf*cm, 69 in.*lbf) 

    3. Connect the connector with the clamp.
    Fig 1: Locating Bolts, Fuel Pump Resistor And Ground Wires
    G05826431Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL ENGINE ROOM SIDE COVER RH  (See INSTALLATION )
  3. INSTALL COOL AIR INTAKE DUCT SEAL  (See INSTALLATION )
scientia non olet · About LEMON Manuals