Section 58 (Emission Control (2GR-FSE)): Canister: Installation

WARNING: This page is about a different car, the 2008 Lexus IS 350. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL CHARCOAL CANISTER ASSEMBLY
1. Install the charcoal canister assembly, 2 spacer and 4 nuts.
  Torque: 5.5 N*m (56 kgf*cm, 49 in.*lbf)
  
  Fig 1: Locating Charcoal Canister Assembly, Spacer And Nuts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Connect the 2 quick connectors, hose and connector.
  
  Fig 2: Locating Quick Connectors, Hose And Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Connect the wire harness with the 2 clamps.
  
  Fig 3: Locating Wire Harness Clamps
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FLOOR UNDER COVER
1. Install the floor under cover with the 4 clips and 5 nuts.
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Fig 4: Locating Floor Under Cover Clips And Nuts
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
PERFORM INITIALIZATION
1. Perform initialization (See INITIALIZATION ).
  NOTE: Certain systems need to be initialized after reconnecting the cable to the negative (-) battery terminal.