Section 55 (Cooling (2GR-FSE)): Radiator: Disassembly

WARNING: This page is about a different car, the 2008 Lexus IS 350. However, it is still accessible from the selected car via links, so may be relevant.

ASSEMBLE SST
SST 09230-01010

Fig 1: Identifying Radiator Support Cushions And Lower Radiator Supports
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
1. Install the claw to the overhaul handle, inserting it in the hole in part A as shown in the illustration.
2. While gripping the handle, adjust the stopper bolt so that dimension B is as shown in the illustration.
  NOTE: If this adjustment is not performed, the claw will be damaged.
  
  Dimension B:
  
  0.2 to 0.3 mm (0.008 to 0.012 in.)
UNCAULK LOCK PLATE
SST 09230-01010 (09231-01010, 09231-01030)

Fig 2: Installing Claw To Overhaul Handle
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
1. Using SST to release the caulking, grip the handle until it is stopped by the stopper bolt.
  
  Fig 3: Releasing Caulking
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE RADIATOR UPPER TANK AND LOWER TANK
1. Lightly tap the bracket of the radiator (or radiator hose inlet or outlet) with a plastic hammer and remove the tank.
2. Remove the O-ring.
  
  Fig 4: Tapping Bracket Of Radiator (Or Radiator Hose Inlet Or Outlet) With Plastic Hammer
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSPECT LOCK PLATE FOR DAMAGE
Inspect the lock plate for damage.

HINT:
- If the sides of the lock plate groove are deformed, reassembly of the tank will be impossible. Correct any deformations with pliers.
- Water leakage will result if the bottom of the lock plate groove is damaged or dented. Repair or replace if necessary.
NOTE: The radiator assembly can be recaulked only twice. After the 2nd time, the radiator core must be replaced.

Fig 5: Inspecting Lock Plate For Damage
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002