Engine Front Oil Seal: Installation

WARNING: This page is about a different car, the 2008 Lexus IS 350. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL TIMING CHAIN CASE OIL SEAL
1. Using SST and a hammer, tap in the oil seal until its surface is flush with the rear oil seal retainer edge.
  SST 09223-22010,09506-35010
  NOTE:
  - Keep the lip free of foreign matter.
  - Do not tap the oil seal at an angle.
    
    Fig 1: Installing Timing Chain Case Oil Seal
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL CRANKSHAFT PULLEY
1. Install the pulley set key to the key groove.
  
  Fig 2: Identifying Pulley Set Key Of Key Groove
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Align the pulley set key with the key groove of the pulley, and slide on the pulley.
3. Using SST, install the crankshaft pulley bolt.
  SST 09213-70011 (09213-70020), 09330-00021
  
  Torque: 250 N*m (2,550 kgf*cm, 184 ft.*lbf)
INSTALL V-RIBBED BELT (See INSTALLATION )
INSTALL RADIATOR ASSEMBLY
HINT:

See INSTALLATION .
CHECK FOR ENGINE OIL LEAKS