LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2008 >> IS 250 RWD, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 52 (Automatic Transaxle) >> Automatic Transmission System >> DTC P2759 Torque Converter Clutch Pressure Control Solenoid Control Circuit Electrical (Shift Solenoid Valve SLU) >> Inspection Procedure

Inspection Procedure

WARNING: This page is about a different car, the 2008 Lexus IS 350. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSPECT TRANSMISSION WIRE (SLU) 
    1. Disconnect the transmission wire connector from the transmission.
    2. Measure the resistance according to the value(s) in the table below.

      Standard resistance 

      TESTER CONNECTION SPECIFIED CONDITION CHART

      Tester Connection Specified Condition 20°C (68°F)
      12 (SLU+) - 4 (SLU-) 5.0 to 5.6 Ω
    3. Measure the resistance according to the value(s) in the table below.

      Standard resistance (Check for short) 

      TESTER CONNECTION SPECIFIED CONDITION CHART

      Tester Connection Specified Condition
      12 (SLU+) - Body ground 10 kΩ or higher
      4 (SLU-) - Body ground ↑
      Fig 1: Identifying Terminals Of E47 Transmission Wire Connector
      G05824075Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

    NG:  Go to step  3

    OK: Go to Next Step 

  2. CHECK HARNESS AND CONNECTOR (TRANSMISSION WIRE - ECM) 
    1. Connect the transmission wire connector to the transmission.
    2. Disconnect the ECM connector.
    3. Measure the resistance according to the value(s) in the table below.

      Standard resistance 

      TESTER CONNECTION SPECIFIED CONDITION CHART

      Tester Connection Specified Condition 20°C (68°F)
      E4-13 (SLU+) - E4-12 (SLU-) 5.0 to 5.6 Ω
      Fig 2: Identifying Terminals Of E4 ECM Connector
      G05824076Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Measure the resistance according to the value(s) in the table below.

      Standard resistance (Check for short) 

      TESTER CONNECTION SPECIFIED CONDITION CHART

      Tester Connection Specified Condition
      E4-13 (SLU+) - Body ground 10 kΩ or higher
      E4-12 (SLU-) - Body ground ↑

    NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

    OK: REPLACE ECM 

  3. INSPECT SHIFT SOLENOID VALVE SLU 
    1. Remove the shift solenoid valve SLU.
    2. Measure the resistance according to the value(s) in the table below.

      Standard resistance 

      TESTER CONNECTION SPECIFIED CONDITION CHART

      Tester Connection Specified Condition 20°C (68°F)
      1 - 2 5.0 to 5.6 Ω
    3. Connect the positive (+) lead with a 21 W bulb to terminal 2 and the negative (-) lead to terminal 1 of the solenoid valve connector, then check the movement of the valve.

      OK: The solenoid makes an operating sound. 

      4. Fig 3: Identifying Shift Solenoid Valve SLU
      G05824077Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

    NG: REPLACE SHIFT SOLENOID VALVE SLU 

    OK: REPAIR OR REPLACE TRANSMISSION WIRE 

scientia non olet · About LEMON Manuals