LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2008 >> IS 250 RWD, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 52 (Automatic Transaxle) >> Automatic Transmission System >> DTC P2716 Pressure Control Solenoid "D" Electrical (Shift Solenoid Valve SLT) >> Description

DTC P2716 Pressure Control Solenoid "D" Electrical (Shift Solenoid Valve SLT): Description

WARNING: This page is about a different car, the 2008 Lexus IS 350. However, it is still accessible from the selected car via links, so may be relevant.

Refer to DTC P0894  .

DTC DETECTION CONDITION CHART

DTC No. DTC Detection Condition Trouble Area
P2716 Open or short is detected in shift solenoid valve SLT circuit for 1 second or more while driving (1-trip detection logic).
  • Open or short in shift solenoid valve SLT circuit
  • Shift solenoid valve SLT
  • ECM

Reference (Using an oscilloscope):

Check the waveform between the terminals SLT+ and SLT- of the ECM connector

Fig 1: Identifying Waveform Between Terminals SLT+ And SLT- Of ECM Connector
G05824064Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Standard: 

Refer to the illustration above.

WAVEFORM REFERENCE

Terminal SLT+ - SLT-
Tool setting 5 V/DIV., 1 ms./DIV.
Vehicle condition Engine idle speed