Typical Enabling Conditions
WARNING: This page is about a different car, the 2008 Lexus IS 350. However, it is still accessible from the selected car via links, so may be relevant.
ALL
TYPICAL ENABLING CONDITIONS
| The monitor will run whenever this DTC is not present. | P0115 - P0118 (ECT sensor) P0125 (Insufficient ECT for Closed Loop) P0500 (VSS) P0748 - P0798 (Trans solenoid (range)) |
| Turbine speed sensor circuit | Not circuit malfunction |
| Output speed sensor circuit | Not circuit malfunction |
| Shift solenoid valve S1 circuit | Not circuit malfunction |
| Shift solenoid valve S2 circuit | Not circuit malfunction |
| Shift solenoid valve S3 circuit | Not circuit malfunction |
| Shift solenoid valve S4 circuit | Not circuit malfunction |
| Shift solenoid valve SR circuit | Not circuit malfunction |
| Shift solenoid valve SL1 circuit | Not circuit malfunction |
| Shift solenoid valve SL2 circuit | Not circuit malfunction |
| ECT {Engine coolant temperature) sensor circuit | Not circuit malfunction |
| KCS sensor circuit | Not circuit malfunction |
| ETCS (Electric throttle control system) | Not system down |
| Transmission range | "D" |
| ECT | 40°C(104°F) or more |
| Spark advance from Max. retard timing by KCS control | 0°CA or more |
| Engine | Starting |
P0766 OFF malfunction (A) and P0776 ON malfunction (A)
TYPICAL ENABLING CONDITIONS
| ECM selected gear | 5th |
| Vehicle speed | 1.2 mph (2 km/h) or more |
| Throttle valve opening angle | 6.5% or more at 2,000 rpm (Conditions vary with engine speed) |
P0766 OFF malfunction (B) and P0776 ON malfunction (B)
TYPICAL ENABLING CONDITIONS
| ECM selected gear | 6th |
| Vehicle speed | 1.2 mph (2 km/h) or more |
| Throttle valve opening angle | 6.5% or more at 2,000 rpm (Conditions vary with engine speed) |