Room Light: Inspection

WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.

INSPECT SPOT LIGHT ASSEMBLY (REAR PERSONAL LIGHT)

Connect a positive (+) lead from the battery to terminal 1 (RRMP) and a negative (-) lead to terminal 3 (RGND).

Check that the rear personal light comes on as shown in the table below

SPECIFIED CONDITION CHART

Condition	Specified Condition
Rear personal light switch LH ON	Rear personal light LH comes ON
Rear personal light switch LH OFF	Rear personal light LH does not come ON
Rear personal light switch RH ON	Rear personal light RH comes ON
Rear personal light switch RH OFF	Rear personal light RH does not come ON

If the result is not as specified, replace the spot light assembly

Fig 1: Identifying Spot Light Assembly Connector Terminals (Rear Personal Light)

INSPECT SPOT LIGHT ASSEMBLY (REAR SEAT LIGHT)
1. Connect a positive (+) lead from the battery to terminal 2 (ILLB) and a negative (-) lead to terminal 5 (LILL)
2. Check that the rear seat light comes on.
  OK: Comes on
  
  If the result is not as specified, replace the spot light assembly.
  
  Fig 2: Identifying Spot Light Assembly Connector Terminals (Rear Seat Light)
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE SPOT LIGHT ASSEMBLY (REAR INTERIOR LIGHT)
1. Connect a positive (+) lead from the battery to terminal 2 (ILLB) and a negative (-) lead to terminal 4 (RILL).
2. Check that the rear interior light comes on.
  OK: Comes on
  
  If the result is not as specified, replace the spot light assembly.
Fig 3: Identifying Spot Light Assembly Connector Terminals (Rear Interior Light)
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002