LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2008 >> IS 250 RWD, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 46 (Seat Belt) >> Front Seat Inner Belt Assembly >> Inspection

Front Seat Inner Belt Assembly: Inspection

WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSPECT FRONT SEAT INNER BELT ASSEMBLY RH 
    1. Measure the resistance between the terminals of the switch when the switch is operated.

      Standard Resistance 

      STANDARD RESISTANCE

      Tester Connection Condition Specified Condition
      T3-2 - T3-3 Seat belt is fastened Below 1 Ω
      T3-2 - T3-3 Seat belt is unfastened 10 kΩ or higher
      Fig 1: Identifying Front Seat Inner Belt Assembly RH Connector Terminals
      G05755127Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSPECT FRONT SEAT INNER BELT ASSEMBLY LH 
    1. Measure the resistance between the terminals of the switch when the switch is operated.
      Fig 2: Identifying Front Seat Inner Belt Assembly LH Connector Terminals
      G05755128Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Standard Resistance 

      STANDARD RESISTANCE

      Tester Connection Condition Specified Condition
      U4-4 - U4-5 Seat belt is fastened Below 1 Ω
      U44 - U4-5 Seat belt is unfastened 10 kΩ or higher
    2. Measure the resistance between the terminals of the front seat inner belt assembly.

      Standard Resistance 

      STANDARD RESISTANCE

      Tester Connection Condition Specified Condition
      A-1 - Q6-2 Always Below 1 Ω
      A-2 - Q6-4 Always Below 1 Ω
scientia non olet · About LEMON Manuals