LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2008 >> IS 250 RWD, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 46 (Seat Belt) >> Front Passenger Seat Belt Warning Light >> Inspection

Front Passenger Seat Belt Warning Light: Inspection

WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSPECT CLOCK ASSEMBLY (w/ Navigation System) 
    1. Remove the clock assembly with the connector still connected (See REMOVAL ).
    2. Apply battery voltage from the wire harness back side between the terminals of the indicator, and check the lighting condition of the front passenger side seat belt warning light.

      Standard 

      STANDARD REFERENCE

      Measurement Condition Specified Condition
      Battery position(+) → Terminal J53-11 (IG+)
      Battery position (-) → Terminal J53-8 (PBEW)      		 Front passenger side seat belt light comes on
      Fig 1: Identifying Clock Assembly Connector Terminals
      G05755102Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSPECT INTEGRATION CONTROL AND PANEL ASSEMBLY (w/o Navigation System) 
    1. Remove the integration control and panel assembly with the connector still connected (See REMOVAL ).
    2. Apply battery voltage from the wire harness back side between the terminals of the indicator, and check the lighting condition of the front passenger side seat belt warning light.

      Standard 

      STANDARD REFERENCE

      Measurement Condition Specified Condition
      Battery position(+) → Terminal J54-4 (IG+)
      Battery position(-) → Terminal J54-13 (PBEW)      		 Front passenger side seat belt light comes on
      Fig 2: Identifying Integration Control And Panel Assembly Connector Terminals
      G05755103Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals