LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2008 >> IS 250 RWD, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 44 (Windshield/WINDOWGLASS) >> POWER WINDOW REGULATOR MOTOR (for Front Door) >> Removal

POWER WINDOW REGULATOR MOTOR (for Front Door): Removal

WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.
  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system (See PRECAUTION ).
    NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
  2. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG  (See DISASSEMBLY )
  3. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL  (See DISASSEMBLY )
  4. REMOVE COURTESY LIGHT ASSEMBLY  (See DISASSEMBLY )
  5. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY  (See DISASSEMBLY )
  6. REMOVE FRONT DOOR INNER GLASS WEATHERSTRIP  (See DISASSEMBLY )
  7. REMOVE FRONT DOOR SERVICE HOLE COVER  (See DISASSEMBLY )
  8. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY  (See DISASSEMBLY )
  9. REMOVE FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY  (See DISASSEMBLY )
  10. REMOVE FRONT POWER WINDOW REGULATOR MOTOR 
    1. Using a "TORX" socket wrench (T25), remove the 3 screws and the front power window regulator motor
      Fig 1: Locating Front Power Window Regulator Motor Screws
      G05321198Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals