POWER WINDOW REGULATOR MOTOR (for Front Door): Installation

WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL FRONT POWER WINDOW REGULATOR MOTOR
NOTE: The regulator arm must be below the intermediate position when installing the power window regulator motor.
1. Using a "TORX" socket wrench (T25), install the front power window regulator motor with the 3 screws.
  Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)
  
  HINT
  
  A new front window regulator uses self-tapping screws to thread new installation holes when inserted
  
  Fig 1: Locating Front Power Window Regulator Motor Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY (See REASSEMBLY )
INSTALL FRONT DOOR GLASS SUB-ASSEMBLY (See REASSEMBLY )
INSTALL FRONT DOOR SERVICE HOLE COVER (See REASSEMBLY )
INSTALL FRONT DOOR INNER GLASS WEATHERSTRIP (See REASSEMBLY )
INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY (See REASSEMBLY )
INSTALL COURTESY LIGHT ASSEMBLY (See REASSEMBLY )
INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (See REASSEMBLY )
INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG (See REASSEMBLY )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
INITIALIZE POWER WINDOW CONTROL SYSTEM
(See CUSTOMIZE PARAMETERS )