LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2008 >> IS 250 RWD, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 43 (Tire Pressure Warning System) >> Tire Pressure Warning System >> DTC C2126/26 Transmitter ID not Received in Main Mode; DTC C2127/27 Transmitter ID not Received in 2nd Mode >> Description

DTC C2126/26 Transmitter ID not Received in Main Mode; DTC C2127/27 Transmitter ID not Received in 2nd Mode: Description

WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.

After all IDs are registered, DTC C2126/26 or C2127/27 is stored in the tire pressure warning ECU and receiver and the tire pressure warning light blinks for 1 minute and then remains on.

When the tire pressure warning ECU and receiver successfully receives radio waves from all the transmitters whose IDs are stored in the ECU, DTC C2126/26 or C2127/27 is cleared and the tire pressure warning light goes off

DTC DETECTING CONDITION CHART

DTC No. DTC Detection Condition Trouble Area
C2126/26
C2127/27
After ID registration is completed, ECU does not receive radio waves from transmitters whose IDs are stored in ECU
  • ID registration failure
  • Tire pressure warning valve and transmitter
  • Tire pressure warning antenna
  • Wire harness or connector
  • Tire pressure warning ECU and receiver

HINT:

If the IDs stored in the tire pressure warning ECU and receiver differ from the transmitter IDs, DTC C2126/26 or C2127/27 is stored. Check that the IDs in the ECU are the same as the transmitter IDs