LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2008 >> IS 250 RWD, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 43 (Tire Pressure Warning System) >> Tire Pressure Warning Reset Switch >> Inspection

Tire Pressure Warning Reset Switch: Inspection

WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSPECT SATELLITE SWITCH 
    1. Disconnect the connector from the satellite switch.
    2. Measure the resistance between the terminals according to the value(s) in the table below
      Fig 1: Identifying Satellite Switch Terminals
      G05752518Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Standard resistance 

      TESTER CONNECTION SPECIFIED CONDITION CHART

      Tester Connection Condition Specified Condition
      J16-2 (LSFT) - J16-5 (E) Satellite switch LH is pressed Below 1 Ω
      J16-2 (LSFT) - J16-5 (E) Satellite switch LH is not pressed 10 kΩ or higher
      J16-3 (SET) - J16-5 (E) Satellite switch ON/OFF is pressed Below 1 Ω
      J16-3 (SET) - J16-5 (E) Satellite switch ON/OFF is not pressed 10 kΩ or higher
      J16-4 (RSEL) - J16-5 (E) Satellite switch RH is pressed Below 1 Ω
      J16-4 (RSEL) - J16-5 (E) Satellite switch RH is not pressed 10 kΩ or higher

      HINT

      If the value is not as specified, replace the satellite switch

scientia non olet · About LEMON Manuals