Washer Nozzle: Removal

WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.

REMOVE WASHER NOZZLE SUB-ASSEMBLY
1. Using a screwdriver, disengage the 2 claws and separate the washer nozzle sub-assembly as shown in the illustration
  NOTE: Be careful not to damage the windshield.
  
  HINT
  
  Tape the screwdriver tip before use
  
  Fig 1: Disengaging Washer Nozzle Sub-Assembly Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Remove the washer nozzle sub-assembly from the washer hose
  NOTE: Washer nozzles cannot be reused.
  
  Fig 2: Locating Washer Nozzle Sub-Assembly From Washer Hose
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002