Toe Control Link: Installation

HINT

• Use the same procedure for the RH side and LH side
• The procedure listed below is for the LH side

1. TEMPORARILY TIGHTEN TOE CONTROL LINK SUB-ASSEMBLY 
   1. Install the toe control link sub-assembly and insert the toe adjust cam from the front of the vehicle Then, install the toe adjust plate and temporarily tighten the nut
      NOTE: Align the matchmarks on the rear suspension member and toe adjust plate.

      HINT

      Fully tighten the nut after stabilizing the suspension

      Fig 1: Aligning Matchmarks On Rear Suspension Member And Toe Adjust Plate

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   2. Install the toe control link sub-assembly with a new nut

      Torque: 70 N*m (714 kgf*cm, 52 ft.*lbf) 

   Fig 2: Locating Toe Control Link Sub-Assembly Nut

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. INSTALL REAR SPEED SENSOR WIRE 
   1. Install the rear speed sensor wire with the bolt

      Torque: 6.0 N*m (61 kgf*cm, 53 in.*lbf) 

   2. Connect the rear speed sensor wire connector
   Fig 3: Locating Rear Speed Sensor Wire Connector

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. STABILIZE SUSPENSION  (See INSTALLATION )
4. FULLY TIGHTEN TOE CONTROL LINK SUB-ASSEMBLY 
   1. Fully tighten the nut on the rear suspension member side

      Torque: 50 N*m (510 kgf*cm, 37 ft.*lbf) 

   Fig 4: Locating Rear Suspension Member Side Nut

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   NOTE: Check that the matchmarks on the rear suspension member and toe adjust plate are aligned.
5. INSTALL REAR WHEEL 

   Torque: 103 N*m (1050 kgf*cm, 76 ft.*lbf) 

6. INSPECT AND ADJUST REAR WHEEL ALIGNMENT 

   See REAR WHEEL ALIGNMENT