LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2008 >> IS 250 RWD, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 38 (Rear Suspension) >> Rear Shock Absorber >> Disposal

Rear Shock Absorber: Disposal

WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.
  1. DISPOSE OF REAR SHOCK ABSORBER ASSEMBLY 
    1. Fully extend the rear shock absorber rod.
    2. Using a drill, make a hole in the cylinder somewhere between A and B, as shown in the illustration, to discharge the gas inside.
    Fig 1: Identifying Disposal Area Of Rear Shock Absorber Assembly
    G05752356Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    CAUTION:
    • Be careful when drilling because shards of metal may fly about. Always use proper safety equipment.
    • The gas is colorless, odorless, and non-poisonous.
scientia non olet · About LEMON Manuals