Front Upper Suspension Arm: Installation

WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.

HINT.

Use the same procedure for the LH side and RH side.
The following procedure listed is for the LH side

INSTALL FRONT UPPER SUSPENSION ARM ASSEMBLY
1. Temporarily install the front upper suspension arm assembly with the 2 bolts.
  HINT.
  
  When installing the front upper suspension arm assembly, temporarily tighten the bolts at the position shown in the illustration
  
  Fig 1: Identifying Front Upper Suspension Arm Assembly Installation Angle
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Fully tighten the front upper suspension arm assembly with the 2 bolts
  Torque: 49 N*m (500 kgf*cm, 36 ft.*lbf)
Fig 2: Locating Front Upper Suspension Arm Assembly Bolts
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
TEMPORARILY TIGHTEN FRONT SHOCK ABSORBER WITH COIL SPRING (See FRONT SHOCK ABSORBER )
INSTALL FRONT UPPER SUSPENSION ARM ASSEMBLY (See INSTALLATION )
INSTALL STEERING KNUCKLE WITH AXLE ASSEMBLY (See INSTALLATION )
INSTALL FRONT DISC (See INSTALLATION )
INSTALL FRONT DISC BRAKE CYLINDER ASSEMBLY (See INSTALLATION )
CONNECT FRONT SPEED SENSOR (See INSTALLATION )
INSTALL FRONT STABILIZER LINK ASSEMBLY (See INSTALLATION )
STABILIZE SUSPENSION (See INSTALLATION )
FULLY TIGHTEN FRONT SHOCK ABSORBER WITH COIL SPRING (See FRONT SHOCK ABSORBER )
INSTALL ENGINE ROOM SIDE COVER LH (See INSTALLATION )
INSTALL COOL AIR INTAKE DUCT SEAL (See INSTALLATION )
INSTALL FRONT WHEEL
Torque: 103 N*m (1050 kgf*cm, 76 ft.*lbf)
CHECK FOR SPEED SENSOR SIGNAL
HINT.

Check for speed sensor signal (See TEST MODE PROCEDURE )
INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
HINT:

Inspect and adjust front wheel alignment. (See ADJUSTMENT )