Front Suspension Member: Installation

WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL POWER STEERING LINK ASSEMBLY
1. Install the power steering link assembly with the 2 bolts, 2 washers, and 2 nuts
  Torque: 118 N*m (1203 kgf*cm, 87 ft.*lbf)
  
  HINT
  
  Install the power steering link assembly together with the front lower suspension arm assembly
Fig 1: Locating Power Steering Link Assembly With Bolts, Washers And Nuts
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT LOWER SUSPENSION ARM ASSEMBLY LH
1. Install the front suspension lower arm assembly LH with the 2 bolts, 2 nuts and 2 washers
  Torque: Bolt B
  
  87 N*m (887 kgf*cm, 64 ft.*lbf)
  
  HINT
  
  Install the power steering link assembly together with the front lower suspension arm assembly
  
  Fig 2: Locating Front Suspension Lower Arm Assembly LH With Bolts, Nuts And Washers
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Set the front lower suspension arm in the horizontal position shown in the illustration.
3. Fully tighten the bolt A
  Torque: Bolt A
  
  135 N*m (1377 kgf*cm, 100 ft.*lbf)
  
  NOTE: The final torque must be applied under standard vehicle height conditions.
  
  Fig 3: Setting Front Lower Suspension Arm
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT LOWER SUSPENSION ARM ASSEMBLY RH
HINT.

Perform the same procedure as the LH side.
INSTALL FRONT STABILIZER BAR
1. Install the front stabilizer bar with the 2 nuts.
  Torque: 84 N*m (857 kgf*cm, 62 ft.*lbf)
  
  HINT
  
  If the ball joint turns together with the nut, use a hexagon wrench (6 mm) to hold the stud bolt.
  
  Fig 4: Locating Front Stabilizer Bar Nuts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT ENGINE MOUNTING INSULATOR (See INSTALLATION )
INSTALL FRONT SUSPENSION CROSSMEMBER SUB-ASSEMBLY (See INSTALLATION )
INSTALL NO.2 EXHAUST MANIFOLD HEAT INSULATOR (See INSTALLATION )
INSTALL NO.1 EXHAUST MANIFOLD HEAT INSULATOR (See INSTALLATION )
INSTALL ENGINE UNDER COVER SUB-ASSEMBLY LH (See INSTALLATION )
INSTALL ENGINE UNDER COVER SUB-ASSEMBLY RH (See INSTALLATION )
INSTALL OIL LEVEL DIPSTICK GUIDE (See INSTALLATION )
INSTALL OIL LEVEL DIPSTICK
INSTALL ENGINE WITH TRANSMISSION ASSEMBLY
HINT:

Install the engine with transmission assembly. (See INSTALLATION )