LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2008 >> IS 250 RWD, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 36 (Front Suspension) >> Front Stabilizer Bar >> Removal

Front Stabilizer Bar: Removal

WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE FRONT WHEEL 
  2. REMOVE ENGINE UNDER COVER 
  3. REMOVE REAR ENGINE UNDER COVER LH 
    1. Remove the bolt and engine under cover LH
      2. Fig 1: Locating Engine Under Cover LH Bolt
      G05752307Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. REMOVE REAR ENGINE UNDER COVER RH 

    HINT.

    Remove the RH side following the same procedure as the LH side.

  5. SEPARATE FRONT HEIGHT CONTROL SENSOR LINK ASSEMBLY 
    1. Remove the nut and separate the height control sensor link assembly
    Fig 2: Locating Front Height Control Sensor Link Assembly Nut
    G05752308Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  6. REMOVE FRONT STABILIZER LINK ASSEMBLY LH 
    1. Remove the 2 nuts and the front stabilizer link assembly LH.
    Fig 3: Locating Front Stabilizer Link Assembly LH Nuts
    G05752309Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

    HINT.

    If the ball joint turns together with the nut, use a hexagon (6 mm) wrench to hold the stud.

  7. REMOVE FRONT STABILIZER LINK ASSEMBLY RH 

    HINT.

    Remove the RH side following the same procedure as the LH side

  8. REMOVE FRONT NO. 2 STABILIZER BRACKET LH 
    1. Remove the 2 bolts and the front No. 2 stabilizer bracket LH from the front suspension crossmember.
    Fig 4: Locating Front No. 2 Stabilizer Bracket LH Bolts
    G05752310Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  9. REMOVE FRONT NO. 2 STABILIZER BRACKET RH 

    HINT.

    Remove the RH side following the same procedure as the LH side

  10. REMOVE FRONT STABILIZER BAR 
    1. Remove the front stabilizer bar from the vehicle.
  11. REMOVE FRONT NO. 1 STABILIZER BRACKET LH 
    1. Remove the skid control sensor wire clamp from the front No 1 stabilizer bracket LH.
    2. Remove the 4 bolts and the front No. 1 stabilizer bracket LH from the frame.
    Fig 5: Locating Front No. 1 Stabilizer Bracket LH Bolts
    G05752311Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  12. REMOVE FRONT NO. 1 STABILIZER BRACKET RH 

    HINT.

    Remove the RH side following the same procedure as the LH side.

  13. REMOVE FRONT NO. 1 STABILIZER BAR BUSHING 
    1. Remove the 2 front No. 1 stabilizer bar bushings from the front stabilizer bar.
scientia non olet · About LEMON Manuals