Front Stabilizer Bar: Inspection

WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.

INSPECT FRONT STABILIZER LINK ASSEMBLY
1. Flip the ball joint stud back and forth 5 times as shown in the illustration.
2. Temporarily install the nut, and use a torque wrench to turn the nut continuously at a rate of 2 to 4 seconds per turn. Take the torque reading on the 5th turn.
  
  Fig 1: Inspecting Front Stabilizer Link Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  Turning torque:
  
  0.05 to 1.96 N*m (0.5 to 20 kgf*cm, 0.4 to 17.3 in.*lbf)
3. Check the dust cover for cracks or grease leakage. If the value is not within the specified range, replace the front stabilizer link assembly with a new one.