LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2008 >> IS 250 RWD, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 33 (Supplemental Restraint System) >> Driver Side Knee Airbag Assembly >> On-Vehicle Inspection

On-Vehicle Inspection

WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSPECT DRIVER SIDE KNEE AIRBAG ASSEMBLY (VEHICLE NOT INVOLVED IN COLLISION) 
    1. Perform a diagnostic system check (See DTC CHECK / CLEAR  )
    2. With the driver side knee airbag assembly installed on the vehicle, perform a visual check If there are any following defects, replace the driver side knee airbag assembly with a new one

      Cuts, minute cracks or marked discoloration on the driver side knee airbag assembly

      Fig 1: Identifying Driver Side Knee Airbag Assembly (Vehicle Not Involved In Collision)
      G05757272Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSPECT DRIVER SIDE KNEE AIRBAG ASSEMBLY (VEHICLE INVOLVED IN COLLISION AND AIRBAG HAS NOT DEPLOYED) 
    1. Perform a diagnostic system check (See DTC CHECK / CLEAR  )
    2. With the driver side knee airbag assembly removed from the vehicle, perform a visual check If there are any following defects, replace the driver side knee airbag assembly with a new one
      • Cuts, minute cracks or marked discoloration on the driver side knee airbag assembly
      • Cracks or other damage to the connector
      • Deformation or cracks on the instrument panel reinforcement
        CAUTION: Be sure to follow the correct removal and installation procedures of the driver side knee airbag assembly.