Clearance Warning Ecu: Installation

WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL CLEARANCE WARNING ECU (w/o Pre-collision System)
1. Install the clearance warning ECU with the 2 nuts.
  Torque: 5.5 N*m (56 kgf*cm, 49 in.*lbf)
2. Connect the connector.
  
  Fig 1: Locating Clearance Warning ECU Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL CLEARANCE WARNING ECU (w/ Pre-collision System)
1. Install the clearance warning ECU to the seat belt control ECU with the 2 nuts.
  Torque: 5.5 N*m (56 kgf*cm, 49 in.*lbf)
2. Temporarily install nut A.
  
  Fig 2: Identifying Clearance Warning ECU Nuts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Insert loosely tightened nut A into the hole on the vehicle body (left side of the luggage compartment). Slide down the seat belt control ECU and the clearance warning ECU as a unit to temporarily install them
4. Insert the 2 bolts into the holes on the vehicle body and fully tighten the 3 nuts in the order of B, A, and C.
  Torque: 5.5 N*m (56 kgf*cm, 49 in.*lbf)
  
  Fig 3: Locating Seat Belt Control ECU Nuts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Connect the connectors
INSTALL SIDE LUGGAGE COMPARTMENT TRIM COVER (See INSTALLATION )
INSTALL NO. 1 LUGGAGE COMPARTMENT TRIM HOOK (See INSTALLATION )
INSTALL FRONT LUGGAGE COMPARTMENT TRIM COVER (See INSTALLATION )
INSTALL NO. 2 LUGGAGE COMPARTMENT TRIM HOOK (See INSTALLATION )
INSTALL ROPE HOOK (See INSTALLATION )
INSTALL NO. 2 ROOM LIGHT ASSEMBLY (See INSTALLATION )
INSTALL REAR LUGGAGE COMPARTMENT TRIM COVER (See INSTALLATION )
INSTALL ROPE HOOK ASSEMBLY (See INSTALLATION )
INSTALL DECK SIDE TRIM BOX RH
INSTALL DECK SIDE TRIM BOX LH
INSTALL LUGGAGE COMPARTMENT TRIM COVER
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).