Data List / Active Test

WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.

DATA LIST

HINT

Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts This on-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before arts or wiring is disturbed Reading the Data List information early in troubleshooting is one way to save diagnostic time

NOTE: In the following table, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

Connect the Techstream to the DLC3
Turn the engine switch on (IG)
Enter the following menus" Body Electrical / Body or Body No 5 / Data List

Read the Data List according to the display on the Techstream

Body

DIAGNOSTIC NOTE CHART

Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
IGSW	Ignition switch signal/ON or OFF	ON Turn the engine switch on (IG) or start OFF Turn the engine switch off or on (ACC)	-
ACC SW	Engine switch signal/ON or OFF	ON Turn the engine switch on (ACC) OFF Turn the engine switch off	-
Luggage Courtesy SW	Luggage compartment door courtesy switch/ON or OFF	ON Luggage compartment door is OPEN OFF Luggage compartment door is CLOSED	-
D Door Courtesy SW	D door courtesy switch/ON or OFF	ON Driver side door is OPEN OFF Driver side door is CLOSED	-
P Door Courtesy SW	P door courtesy switch/ON or OFF	ON Front passenger side door is OPEN OFF Front passenger side door is CLOSED	-
Rear Door Courtesy SW	Rear door courtesy switch/ON or OFF	ON Rear door is OPEN OFF Rear door is CLOSED	-
Passenger Lock Pos SW	Passenger lock position switch/ ON or OFF	ON Passenger door is UNLOCKED OFF Passenger door is LOCKED	-
Rear Lock Position SW	Rear lock position switch/ON or OFF	ON Rear door is UNLOCKED OFF Rear door is LOCKED	-
Warning by Horn	Warning by horn/ON or OFF	ON Vehicle horns sound during alarm sounding state OFF Vehicle horns do not sound during alarm sounding state	-
Passive Mode	Passive mode/ON or OFF	ON Passive mode ON OFF Passive mode OFF	-
Entry Delay Time	Entry delay time during passive mode	Os Entry delay time is 0 sec 14s Entry delay time is 14 sec 30s Entry delay time is 30 sec	-

Body No. 5

DIAGNOSTIC NOTE

Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
Hood Courtesy SW	Engine hood courtesy switch signal/ON or OFF	ON Engine hood is OPEN OFF Engine hood is CLOSED	-

ACTIVE TEST

HINT.

Using the Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed Performing Active Tests early in trouble shooting is one way to save diagnostic time Data List information can be displayed while performing Active Tests

Connect the Techstream to the DLC3
Turn the engine switch on (IG)
Enter the following menus: Body Electrical / Body or Body No. 5 / Active Test

Perform the Active Test according to the display on the Techstream

Body

DIAGNOSTIC NOTE

Tester Display	Test Part	Control Range	Diagnostic Note
Security Indicator	Security indicator	ON/OFF	-
Security Horn	Security horn	ON/OFF	-
Hazard	Hazard warning light	ON/OFF	-

Body No. 5

DIAGNOSTIC NOTE

Tester Display	Test Part	Control Range	Diagnostic Note
Horn Relay Operation	Vehicle horn	ON/OFF	-