Inspection Procedure

1. Perform initialization (See INITIALIZATION )

1. Clear the DTC (See DIAGNOSIS SYSTEM  )
2. Check if the trouble occurs again 18 to 22 seconds after the engine switch is turned on (IG)

   Result 

   RESULT REFERENCE
   
   

   Result	Proceed to
   DTC B2288 is output	A
   DTC B2285 is output	B
   DTC is not output	C

B: GO TO OTHER FLOWCHART (DTC B2285)  (See DTC B2285 STEERING LOCK POSITION SIGNAL CIRCUIT MALFUNCTION  )

C: END (INITIALIZATION WAS NOT COMPLETED) 

A: Go to next Step 

1. Connect the Techstream to the DLC3
2. Turn the engine switch on (IG)
3. Check for Steering Lock System DTC

   OK: DTC is not output. 

NG: GO TO DIAGNOSTIC TROUBLE CODE CHART (STEERING LOCK SYSTEM)  (See DIAGNOSTIC TROUBLE CODE CHART )

OK: Go to next Step 

1. Check if the steering lock is released when turning the engine switch on (ACC)

   OK: The steering lock is released. 

NG: GO TO STEERING LOCK SYSTEM (STEERING LOCK CAN NOT BE UNLOCKED)  (See PROBLEM SYMPTOMS TABLE )

OK: Go to next Step 

1. Connect the Techstream to the DLC3
2. Turn the engine switch on (IG)
3. Check the Data List for proper functioning of the steering lock function

   HINT

   When using the Techstream with the engine switch off, turn on and off any of the door courtesy light switches repeatedly at 1 5 second intervals or less until communication between the Techstream and vehicle starts

   Power Source Control 

   ITEM RANGE REFERENCE
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   Steering Unlock Switch	Steering lock condition / ON or OFF	ON Steering is unlocked (Engine switch on (ACC)) Steering is locked (Engine switch off)	-

   OK: "ON" (Steering is unlocked) and "OFF" (Steering is locked appear on the screen. 

NG: REPLACE STEERING LOCK ECU  (See DISASSEMBLY )

OK: REPLACE POWER SOURCE CONTROL ECU