LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2008 >> IS 250 RWD, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 24 (Theft Deterrent / Keyless Entry) >> ELECTRICAL KEY OSCILLATOR (for Front Door) >> Installation

ELECTRICAL KEY OSCILLATOR (for Front Door): Installation

WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL DOOR ELECTRICAL KEY OSCILLATOR 
    1. Install the door electrical key oscillator with the screw
    Fig 1: Locating Door Electrical Key Oscillator And Screw
    G05754552Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL FRONT DOOR OUTSIDE HANDLE FRAME SUB-ASSEMBLY  (See REASSEMBLY )
  3. INSTALL FRONT DOOR LOCK ASSEMBLY  (See REASSEMBLY )
  4. INSTALL FRONT DOOR REAR OUTSIDE HANDLE PAD  (See REASSEMBLY )
  5. INSTALL FRONT DOOR FRONT OUTSIDE HANDLE PAD  (See REASSEMBLY )
  6. INSTALL FRONT DOOR OUTSIDE HANDLE ASSEMBLY  (See REASSEMBLY )
  7. INSTALL FRONT DOOR LOCK CYLINDER ASSEMBLY (for Driver Side)  (See REASSEMBLY )
  8. INSTALL FRONT DOOR OUTSIDE HANDLE COVER (for Driver Side)  (See REASSEMBLY )
  9. INSTALL FRONT DOOR OUTSIDE HANDLE COVER (for Front Passenger Side)  (See REASSEMBLY )
  10. INSTALL FRONT DOOR REAR LOWER FRAME SUB-ASSEMBLY  (See REASSEMBLY )
  11. INSTALL FRONT DOOR SERVICE HOLE COVER  (See REASSEMBLY )
  12. INSTALL FRONT DOOR TRIM COVER  (See REASSEMBLY )
  13. INSTALL FRONT DOOR INNER GLASS WEATHERSTRIP  (See REASSEMBLY )
  14. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY  (See REASSEMBLY )
  15. INSTALL COURTESY LIGHT ASSEMBLY  (See REASSEMBLY )
  16. INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)  (See REASSEMBLY )
  17. INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)  (See REMOVAL )
  18. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG  (See REASSEMBLY )
  19. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
    NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
  20. INITIALIZE POWER WINDOW CONTROL SYSTEM 

    (See INITIALIZATION )

scientia non olet · About LEMON Manuals