LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2008 >> IS 250 RWD, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 22 (Automatic Transaxle) >> Transmission Wire >> Removal

Transmission Wire: Removal

WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE NO. 2 ENGINE UNDER COVER 
  2. REMOVE NO. 1 EXHAUST PIPE SUPPORT BRACKET SUB-ASSEMBLY  (See REMOVAL  )
  3. DRAIN AUTOMATIC TRANSMISSION FLUID  (See REMOVAL  )
  4. REMOVE AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY  (See REMOVAL  )
  5. REMOVE VALVE BODY OIL STRAINER ASSEMBLY  (See REMOVAL  )
  6. REMOVE TRANSMISSION VALVE BODY ASSEMBLY  (See DISASSEMBLY  )
  7. REMOVE TRANSMISSION WIRE 
    1. Disconnect the 3 speed sensor connectors.
      Fig 1: Locating Speed Sensor Connectors
      G04948439Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disconnect the wire connector

      HINT:

      Detach the claw, press down the lever, and then disconnect the transmission wire connector.

      Fig 2: Pressing Down Lever
      G05750824Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Using a 10 mm union nut wrench, remove the bolt and pull out the transmission wire.
    4. Remove the O-ring from the transmission wire connector.
      Fig 3: Pulling Out Transmission Wire
      G05750825Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals